Lỗi 127 – Lỗi Chung của Thiết Bị (Alarm General Unit Error)
| Nguyên nhân (Cause) | Hành động khắc phục (Action) |
|---|---|
|
Alarm General Unit Error • The surveillance has determined that the unit is not capable of continue running, and has shut down. • The reason is displayed at the controller main screen, and is stated at the event next to the alarm event. • Known reason to the shutdown state is:
Lỗi Chung của Thiết Bị • Hệ thống giám sát xác định rằng thiết bị không thể tiếp tục hoạt động và đã tắt. • Nguyên nhân được hiển thị tại màn hình chính của bộ điều khiển và ghi rõ tại sự kiện báo động. • Các lý do có thể khiến thiết bị ngừng hoạt động:
|
“SET POINT OUT OF RANGE” • The temperature set point is outside valid operation range. +30°C to -40°C (+35°C with extended range). • Check configurations and settings on the controller. → Nhiệt độ cài đặt vượt quá giới hạn vận hành hợp lệ. Kiểm tra cấu hình và cài đặt trên bộ điều khiển. “VOLTAGE OUT OF RANGE” • The measured voltage is below 330VAC. • Check power line voltage while loaded. → Điện áp đo được dưới 330VAC. Kiểm tra điện áp đường dây khi tải. “POWER LINE PHASE ERROR” • The phase detection system detects phase error or not capable of securing the correct rotation. • Check power line voltage and quality. → Hệ thống phát hiện lỗi pha hoặc không thể đảm bảo chiều quay đúng. Kiểm tra điện áp và chất lượng nguồn. “REGULATION PROBE ERROR” • If supply and return air temperature sensor and evaporator coil temperature sensors ALL indicate OPEN or SHORT circuit, the software is not capable of determine a reasonable action related to the cargo. • Follow steps related to the sensor alarms. → Nếu tất cả cảm biến gió cấp, gió hồi và dàn bay hơi đều báo mạch hở hoặc ngắn mạch, phần mềm không thể xác định hành động hợp lý. Làm theo các bước liên quan đến lỗi cảm biến. “COMPRESSOR TEMPERATURE HIGH” • The compressor temperature is measured to be above 148°C. The state will stay until compressor temperature is measured to be below 132°C. • Check refrigerant level and flow through the cooling circuit. → Nhiệt độ máy nén vượt quá 148°C và sẽ không khôi phục cho đến khi xuống dưới 132°C. Kiểm tra mức gas và lưu lượng qua hệ thống làm lạnh. |
Để lại một bình luận