High Pressure Switch Off Error
• Occurs during pretrip (PTI) test only.
• Compressor does not stop during high pressure cutout switch test.
• Indicates:- Faulty compressor contactor or control circuit.
- Low refrigerant charge.
- Defective high pressure cutout switch.
- Strong winds cooling condenser coil in low ambient conditions.
Lỗi Công Tắc Áp Suất Cao Không Ngắt
• Xảy ra trong quá trình kiểm tra pretrip (PTI).
• Máy nén không dừng khi kiểm tra công tắc cắt áp suất cao.
• Cho thấy:- Contactor máy nén hoặc mạch điều khiển bị lỗi.
- Thiếu môi chất lạnh.
- Công tắc áp suất cao bị lỗi.
- Gió mạnh làm mát dàn ngưng trong môi trường nhiệt độ thấp.
| - Check discharge and suction pressure gauge readings and refrigerant charge.
→ Kiểm tra chỉ số áp suất xả/hút và lượng môi chất lạnh. - Enter Manual Function Test menu:
- Start compressor (100%), condenser fan, and evaporator fan at high speed.
- Discharge pressure should rise until:
2250 kPa / 22.5 bar / 326 psig, then compressor stops (switch opens).
→ Vào chế độ kiểm tra thủ công, khởi động đầy đủ quạt và máy nén để tăng áp suất xả.
Khi áp suất đạt 2250 kPa (22.5 bar, 326 psig), máy nén phải ngắt (công tắc mở).
|
Để lại một bình luận